国产精品一区第二页,久久精品综合免费观看,国产性爱在线观看欧美亚洲黄片,99热免费国产在线播放www.yunkeping.com

The debugging procedure of the precision four-column cutting machine is ready for the machine placement position. The three-phase power supply anti-wear hydraulic oil (please buy brands such as Great Wall, Shell, etc.) before the machine is placed, the spare rubber pad is placed at the machine foot, and the machine pedal is fixed. wire. Install the spare two brackets. Use a hexagonal wire cutter to open the cover in the middle of the machine, anti-wear hydraulic oil. After the machine is connected, (three fire lines, one ground wire) after connecting the line, turn on the machine power switch, turn on the oil pump work switch, immediately turn off the power switch; the staff face the motor fan blade, see the motor fan blade clockwise or reverse When the hour hand turns, it must be turned clockwise. If the motor fan blade rotates counterclockwise, in the case of power failure, the position of a live wire can be arbitrarily adjusted. The machine is warmed up, the cutting depth is adjusted to close the setting switch, the setting handle is moved down to the middle position, and the hand is pressed by the row cutting button to preheat the machine for more than ten times. Place a pallet on the work surface (the plank can be lifted, white up), put a nylon pad on the pallet (the size of the pad is as large as the work surface), the pad is in the middle position; In the middle of the board, the knife edge is facing down. After the release, push the pallet into the machine work surface, the edge of the pad is exactly the same as the edge of the machine work surface. Release the setting handle (turn the handle counterclockwise) to open the setting switch. At this point, the machine descends and presses the die, the pad, and the pallet. Move the setting handle up and down a few times to prevent the setting from coming down. Tighten the setting handle (clockwise) to close the setting switch. Pull the pallet out, place the material (waste material) under the die (the blade facing material), and push the pallet into the work surface. The edge of the pad is aligned with the edge of the work surface. At this point, look at the cutting depth must be otherwise it will damage the die. Press the button on the top of the machine with both hands. After cutting, pull out the pallet to see if the material is cut. If it is not cut, fine-tune the cutting depth, adjust a scale and try to see the effect; if it is not cut, then adjust a scale and try again; there is still one point that has not been cut, then adjust the half-scale and try again. Only after you have just cut it, you can adjust half a scale. Remember to only fine-tune the cutting depth. Warning: Workers must not reach into the work surface at any time!