Belt embossing machine precautions
1. This unit must be equipped with a good ground terminal (connected to the correct ground)
2. The machine is extremely sensitive to moisture and dust and needs to be placed in a suitable working space.
3. The vacuum tube of the machine will generate high heat, so it should not be placed next to the machine that will generate high heat, nor should it be installed in the place where the solar energy is directly irradiated. For the above reasons, it will affect the heat dissipation function of the vacuum tube.
4. If the machine is shut down for more than one hour, and then turn on the machine, wait 10-15 minutes to warm the vacuum tube and protect the service life of the vacuum tube.
5. The upper and lower extremes of the machine (upper and lower molds) cannot be directly touched together, and there must be insulation and work pieces between them.
6. When operating, when high-cycle output, remember not to touch the upper pole output (ie, the upper die), nor can you use the universal meter, test meter or other low-frequency, low-voltage instruments, try to directly measure the upper pole output, this will Causing an accident
7. Regularly check the insulation of the lower (lower mold). If there is damage, burnt or breakdown, replace the insulation immediately. Otherwise, if it continues to work, it will produce sparks and cannot complete the process.
8. If sparks occur frequently (when the upper and lower molds are touched together, high-cycle output) without checking the repair, the machine parts will be damaged and the work will be affected.
9. The work used to make the finished product should be free of moisture and dust, because the above objects are easy to cause sparks.
10. After the machine is turned on, you will hear the sound of the fan turning (4KW, 5KW sound is small). This is used for heat dissipation of the vacuum tube. If the fan is faulty, it must be repaired immediately, otherwise the vacuum tube will be damaged.